Wireless DAQ Module
The TSi Wireless Data Acquisition Module has been designed to collect data and implement a full IEEE 802.11b/g network interface. It includes multiple I/O ports for interaction with standard sensors and control systems. An on-board Wireless module with built in antenna, along with all required RF, baseband, and application-processor circuitry enables the data communication over WiFi. Depending on the configuration of the application firmware, the module can operate as an embedded communication module under the control of a Host application, or as an application Host. Ten channel buffered I/O lines, five GPIO ports, UART, SPI, I2C and an 8-bit parallel bus makes this device one of the most versatile data acquisition modules on the market.
Features
- Multiple I/O ports for real-time data acquisition
- Implements a fully WiFi compatible IEEE 802.11b/g network interface
- Analog Ports:
10 independent 12 bit 0-5V input ports with 4kHz max sampling - General Purpose I/O:
5 GPIO lines with 5V TTL logic for control and monitoring - Parallel Bus:
8-bit parallel input bus with external clock control for high-speed data communication and peripheral interface - UART:
Standard UART port with 3 different interface selections (5V Logic, RS232 Logic and USB), 9600 – 921600 bps - Serial Peripheral Interface (SPI):
8/16 mode read/write operations with over 7MHz clock rate - Inter-Integrated Circuit (I2C):
Standard I2C devices supported with 400 and 1kbps clock rate - 6-9V input supply with indicator LEDs